Automatically Setting Up Programme
SettingsSettings All Settings iconAll Settings icon General Programmes Programme Tuning (Programme Tuning & Settings) Auto Tuning
Automatically tunes the programmes.
  1. Select Country where the TV is used. Programme settings change depending on the country you choose.
  2. Initiate Auto Tuning.
  3. Select programme tuning modes.
  4. Set Auto Tuning following screen instructions.
If Input Source is not connected properly, programme registration may not work.
Auto Tuning only finds programmes that are currently broadcasting.
If Safety is turned on, a pop-up window will appear asking for password.
Set Cable Setting
When searching for programmes using FULL setting it can take a long time.
The following values are needed in order to search all available programmes quickly and correctly. The commonly used values are provided as “default”.
The configurable items differ depending on Type.
Frequency (kHz)
Enter a user-defined frequency.
Symbol Rate (kS/s)
Speed at which a device such as modem sends symbols to a programme.
Modulation
Loading of audio or video signals onto carrier.
Network ID
Unique identifier allocated for each user.
Start Frequency (kHz)
Enter a user-defined start frequency range.
End Frequency (kHz)
Enter a user-defined end frequency range.
Set Satellite Setting
You can add/delete/set the satellite you want.
This function only works when the programme mode is satellite.
Satellite
Select your desired Satellite.
LNB Frequency
Select one value from 9750/10600, 9750/10750, 9750, 10600, 10750, 11300, 5150, MDU1, MDU2, MDU3, MDU4, MDU5. If you select 9750/10600, 9750/10750(MHz), 22kHz Tone is disabled. If you cannot find the LNB frequency value from the list, select User and manually enter the frequency.
Some models may not be supported.
Transponder
Select the transponder you want to tune.
22kHz Tone
When using 22kHz Tone switch, select 22kHz or 0 Hz. If you use 22kHz Tone, Unicable and Motor Type are disabled.
LNB Power
To enable the power supply for the LNB, select On. If you select Off, Motor Type is disabled.
DiSEqC
When using DiSEqC, select one option from A~D/ToneA~B. If you use DiSEqC, Unicable and Motor Type are disabled.
Unicable
Select On to use Unicable and set the Unicable in the Unicable Settings menu. When Unicable is enabled, 22kHz Tone, DiSEqC, Motor Type are disabled.
Motor Type
Select Motor Type to use Motor and set the Motor in the Motor Setting menu. When Motor is enabled, 22kHz Tone, DiSEqC, Unicable are disabled.
If you set satellite to others, you must add a transponder using Transponder Edit.
When selecting 22kHz Tone and DiSEqC, you must connect them in the same position as displayed on the OSD.
If you delete a Satellite, all programmes stored in the Satellite are deleted.
Set Motor Setting
DiSEqC 1.2 : Control motor to change satellite dish position.
Drive Direction
Select the direction in which you want to move the motor.
Drive Mode
Two modes are available : Step and Continuous.
  • Step : The motor moves based on the value you enter (from 1 to 128).
  • Continuous : The motor moves continuously until you press the Stop.
Test Transponder
Select the test Transponder you want to tune.
Set Limit
Set the motor movement to east or west to have the motor move only within the direction set.
  • On : You can limit the movement to the current direction by selecting the West/East.
  • Off : You can cancel the limit you set.
Go to 0
You can move the motor to Zero.
USALS : Set your current location (Longitude/Latitude).